Setup Guideline for the Soap Dispenser
Press button to adjust amount of soap desired. Continue pressing up to 3 times to increase dispensing amount with each press.
Level 1: Blue light flashes once, dispenser pumps 0.3g foam/0.8ml liquid.
Level 2: Blue light flashes twice, dispenser pumps 0.6g foam/1.4ml liquid.
Level3: Blue light flashes three times, dispenser pumps 0.9g foam/2ml liquid.
Press for 3 seconds to turn on. Blue light turns on to indicate power on. Device is in stand by mode when blue light flashes every 6 seconds. Press and hold for 3 seconds to turn off. Red light flashes to indicate powering off.
Place hand within 8[±2cm) below the sensor to dispense soap. Device returns to standby mode [blue light flashes every 6 seconds] after dispensing.
*For first time use, or first use aftera soap refill, place hand underneath the sensor to activate it 5 times for device to begin pumping.
When amount of soap dispensed is less than normal, check window to view soap level. Before refilling, switch off the power.
Press the top to pop open the lid. Pour soap into the container. Place lid back onto dispenser, then turn on power to continue use.
When the Red indicator light flashes to signal low power. Use the provided USB charging cord to charge the dispenser ladaptor plug (not included). While charging, red indicator light flashes slowly. When indicator light turns blue without flashing, dispenser is fully charged.